MonoStar® - Phazer®

Features & Benefits:

Fewer coats compared to 20% solids. Two coat scrub and recoat and three/four coat full strip application - time and labor savings versus conventional systems

Superior leveling with string mop - Excellent application appearance

Medium to low burnishing frequency - Great option for most customers

Uses/Solutions:

Hallways and high traffic areas

Can be applied over any conventional resilient finish/sealer and on resilient and other type of natural and man made floors.

Designed for medium to low maintenance routines

Can be used for two-coat scrub and re-coat and three-coat full strip applications

Directions for Use:

Full Strip Preparation:

Strip the floor with an Ecolab brand stripper at the recommended use dilution. Rinse well and let dry.

Scrub and Recoat Preparation:

Deep scrub with an Ecolab brand neutral or alkaline cleaner using a blue pad. Rinse and let dry.

Sealing the Floor:

A sealer is not required with MonoStar on most resilient floors. For porous substrates, such as terrazzo, apply 1-2 coats of Ecolab brand sealer for maximum performance.

Maintenance:

Dust mop daily. Autoscrub or damp mop with an Ecolab brand cleaner. Prepare floors with Ecolab brand cleaners/maintainers prior to burnishing. Burnish 1-4 days/week.

Directions for Phazer Mobile System Use:

Set-up:

• Pre-rinse the applicator pad; wring out and center the pad onto the applicator head.
• Place a bag of product into the pack with the bag spout at the bottom of the pack and facing out. Lock the spout into position. Close the cover and secure the locking strap.
• Attach the delivery tube by rotating the tube connector onto the spout and hand tighten. Put on the pack and adjust the straps.

Application Method:

• Plan your route to maintain a wet leading edge. Work in sections.
• Depress the lever on the applicator handle to dispense product as needed.
• Coats are most commonly applied at 1750 ft2/U.S. gallon (42 m2/L).
• Work the applicator pad through a small puddle of product to pre-load the pad.
• Outline the first section and fill in using an overlapping figure-8 pattern; overlap the outline.
• Start slowly and build speed over time to avoid ridges, splashing and missed areas.
• The average dry time before walking on floor will be 15-40 minutes; allow approximately 40 minutes between coats.
• Remove using any Ecolab floor finish stripper. Follow label directions.

Clean-up:

• Remove the tube connector from the spout. Attach the tethered adapter. Activate the handle lever and hold the connector under running water. Rinse out the system thoroughly.
• Rinse the exterior of the bag spout.
• Immerse the applicator pad in water (do not allow the finish to dry on the pad). Rinse well under running water. Wring and hang the pad to dry.